> ## Content Index
> Fetch the complete content index at: https://kj5shu.com/llms.txt
> Use this file to discover other available public pages before exploring further.

# The 10-Meter Dipole
- URL: https://kj5shu.com/10m-dipole/
- Published: 2026-11-21T04:12:57.000Z
- Updated: 2026-11-21T06:09:35.000Z
- Author: Graham Pointer
- Tags: Build Journeys

[← All Build Journeys](https://kj5shu.com/build-journeys/)Project 02 · Built, with excellent initial SWR

Two Pieces of Wire and a 3D Printer

After wrestling with the EFHW, I decided I needed a win.

Something simple.

Something that didn't involve another evening of wondering whether I'd wound a transformer correctly.

A half-wave dipole for 10 meters seemed like a good candidate.

## Shopping in my own shop

One nice thing about owning an electronics repair business is that I don't necessarily have to order every little component.

I already had wire. I had connectors. I had screws and other hardware.

And I have a 3D printer.

I needed a center support for the dipole, so rather than purchasing one, I made a printable center piece to hold an SO-239 connector and support the two antenna elements.

Nothing particularly sophisticated.

Just something that would do the job.

I cut two lengths of wire, approximately 8½ feet each, attached them to opposite sides of the connector, and assembled the antenna.

There's something satisfying about a project where almost everything comes from parts already sitting in the shop.

## A surprisingly good result

I got the antenna up, connected the coax, and checked the SWR.

**1:1.**

Seriously?

After all the trouble with the EFHW, this thing was practically effortless.

I had built a basic antenna out of inexpensive wire, a connector, and a plastic part I printed myself, and the radio was showing an excellent match.

Of course, an SWR reading doesn't tell the entire story.

I still needed to hear somebody.

## The sideband incident

Initially, 10 meters seemed pretty dead.

Mostly static.

Then I began hearing Morse code around 28.350 MHz. I couldn't understand it, but at least it was a signal.

Later, I discovered something that made me feel a little ridiculous.

I had been listening in lower sideband.

For normal 10-meter SSB voice operation, I needed upper sideband.

One button press later, things started making considerably more sense.

It was one of those moments where the equipment was doing exactly what it was supposed to do. The operator just needed a little adjustment.

## Why I like this antenna

It represents almost everything I enjoy about tinkering.

I had a need, looked around the shop, found most of what I needed, fabricated the part I didn't have, and built something useful.

It didn't require a commercial antenna or expensive specialty hardware.

Just some basic understanding, a few measurements, and a willingness to try.

I've still got operating and testing to do, but this was one of my first really satisfying antenna builds.

## What I'd do differently

![](https://kj5shu.com/content/images/2026/11/2476.jpg)

First trial run of the antenna, 1:1 SWR but not geting out

I'd document the actual wire lengths and feedpoint construction more carefully.

I'd also take better photographs of the 3D-printed center before installing the antenna.

Fortunately, it's a simple enough project that I can always build another one.

## Parts I used (and things still on the list)

- [3D-printed dipole center — Thingiverse model](https://www.thingiverse.com/thing:6834473?ref=kj5shu.com)
- Wire, SO-239 connector, mounting hardware, coax

Additional specific part links and photos will be added as the builds progress.

[← All Build Journeys](https://kj5shu.com/build-journeys/)